3/28/2024 0 Comments Parallel port cnc pinout![]() ![]() Then when sending a HIGH or LOW to the port the DMM will read either 0v or 5v. ![]() Say we are going to check D1 port then we connect the tester to PIN2, see diagram. Use the pos test leed and touch it to the port you want to check. Procedure for taking a reading, Use you DMM and connect ground to the LPT ground. If you do not know what a Parallel port is or just need an addition description then check here first.įirst we will check the LPT port directly by taking a reading. ****** This Instructable uses 220 AC so take extra procation when working with mains ****** So if you choose to do this you have been warned. The parts i feal would be the best to fit me and make something out of it. I will take part of something from here and part from there. That gives me 4 more for some future use, or nothing.Īs with most of the stuff i build it is rarely all from one place. There is 8 ports available but as of now i am only using four. I mainly use manual mode and turn lights on and off as needed. This program does a lot more than i use it for. So where did i get it? From the endless hours of research i do online i just found it.īut do not worrie i have it available for download. You can get to a Lalim software company, but not for this program. The patent was no longer valid scenes 2009 and the direct link to this controller is no longer working. The software is from Lalim, version 3.0.6. This is my version of controlling external devices with your computer. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |